The precaution of using the masterbatch

It is very simple to mix with the masterbatch resin by hand.

The following problems should be paid attention to in the operation of the equipment（masterbatch):

1. (masterbatch)The mixing chamber of injection molding machine or extruder generally has multiple temperature areas, and the temperature near the blanking port should be slightly higher. This is to make the color masterbatch melt quickly after entering the mixing chamber and mix evenly with plastic resin as soon as possible, which is conducive to the good dispersion of Color Masterbatch pigment in products.

2. (masterbatch)Properly apply back pressure to the injection molding machine, which can improve the mixing effect of the screw and facilitate the dispersion of pigment. The side effect of applying back pressure is to slow down the injection speed.

3. Properly increasing the die temperature of the extruder can increase the brightness of the product.